How to Fix Scratched Glass Much like the Pros

Since way back when, craftspeople who are working with glass have relied on a rare-earth compound called Cerium Oxide to polish and get rid of light scratches from glass of all the types. They still do. And you are able to, too. No content is more effective, versatile or easier wear for straightforward glass polishing, restoration and scuff, scratch and also stain removal.


Cerium Oxide powder can also be a lower priced alternative to most pre-mixed polishing compounds already on the market. It mixes very easily with water into a slurry and a little goes a very long way. And if there is some slurry left over as soon as the role is done, you do not throw it out. Just let it dry out so you are able to re use it later merely by adding water.

In case you are a do-it-yourselfer with even modest abilities, all you have to reinstate lightly scratched house windows, tabletops, mirrors, auto glass or even headlights like a pro is a small bit of Cerium Oxide, a felt buffing wheel and an electrical drill to attach it to.

If you’ve grime on your stains or glass on a shower door caused by water that is hard and they also do not come off with household cleaning solutions, Cerium Oxide will take good care of the issue.

To begin with, what is a “light” scratch? The principle of thumb (literally) is the fact that in case you are able to distinctly feel a scratch in the glass of yours with a fingernail, it could be too serious to polish out so the risk of aiming to do it yourself is probably not well worth it. Nonetheless, in case you have a hazy mass of superficial scratches brought on by keys or coins, it’s Cerium Oxide to the rescue.

Cerium Oxide and a felt buffing wheel about three inches in diameter are found online. Remember, you don’t need a lot. Here’s the way to do it:

• Clean the area you’re about to work on, using a lint free fabric or paper cloth

• Get two little plastic tubs, a pint to a quart in dimension and fill one halfway with water

• Place the buffing controls into the water to give it time to get thoroughly damp, but not dripping wet

• Scoop a couple TBSP of Cerium Oxide into the other tub and add a splash of water

• Use a plastic spoon or perhaps knife to mix the mixture and keep adding small quantities of h20 until the slurry gets to the consistency of heavy cream. (It’s definitely safe to check out with your bare finger. And do not worry if there are small molecules which do not totally dissolve.)

• Attach glass scratch removal dampened polishing wheel to your electricity drill and dip it into the slurry

• Place the polishing steering wheel on the work area and rev up your drill

• Keep the pad moving continually side to side and in a circular motion

• Keep buffing until the slurry is practically dry (CAUTION: Be certain to never buff the glass when it is dry. This can result in the cup to overheat and crack.)

• When the slurry dries, wipe it off

• If the glass hasn’t been cleared up to your satisfaction, you just need to repeat the buffing procedure together with the slurry dampened pad

That’s all there is to it. And don’t forget, the slurry may be stored until it is dry then re activated by merely adding water. Happy polishing!

Leave a Reply

Your email address will not be published. Required fields are marked *